LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2023 >> 3 Turbo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Manual Transaxle) >> Manual Transaxle Removal/Installation >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Manual Transaxle Removal/Installation: Notes

WARNING: This page is about a different variant/trim than selected.

Special Service Tool (SST) 

  1. Mazda SST number
  2. Global SST number
  1. 49 C017 5A0
  2. -

    Engine support set
G15737504Courtesy of MAZDA MOTORS CORP.
  1. 49 UN30 3050
  2. 303-050

    Engine lifting bracket
G15737505Courtesy of MAZDA MOTORS CORP.
  1. 49 L017 5A0
  2. -

    Support hanger
G15737506Courtesy of MAZDA MOTORS CORP.
CAUTION:
  • Performing the following procedures could cause an open circuit in the front ABS wheel-speed sensor wiring harness if it is pulled by mistake. Before servicing, disconnect the front ABS wheel-speed sensor and set it aside so that the wiring harness will not be pulled by mistake.
  • Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spring could be damaged.
scientia non olet · About LEMON Manuals