Rear Body Control Module (RBCM) Inspection: Notes
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Remove the following parts:
- Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION .)
- Bass-box (With Bose®) (See BASS-BOX REMOVAL/INSTALLATION .)
- Sub-trunk (See SUB-TRUNK REMOVAL/INSTALLATION .)
- Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
- Trunk side trim (LH) (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
- Remove the rear body control module (RBCM) from the body with the connector connected. (See REAR BODY CONTROL MODULE (RBCM) REMOVAL/INSTALLATION .)
- Connect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Verify that the voltages of each of the terminals are as indicated in the Terminal Voltage Table (Reference).
- If the voltage is not as indicated in the table, inspect the parts under Inspection item(s).
- If the system does not launch normally even though inspection items are normal, specify the location of the malfunction based on the instructions from the on-board diagnostic system and the symptom troubleshooting, and perform repairs.
- If the voltage is not as indicated in the table, inspect the parts under Inspection item(s).