Verify Fuse Block Replacement
- Temporarily connect the negative battery terminal to verify that the related wiring harness is not heated.
- Switch the ignition ON (engine off).
- Verify that the fuse is not blown and the related wiring harness is not heated.
- Inspect for DTCs. (Refer to DTC INSPECTION
in the service information)
- If a DTC is displayed, repair the malfunctioning location according to the applicable DTC troubleshooting.
- After completion of repairs, clear all DTCs stored in the module. (Refer to
CLEARING DTC
in the service information)
- If there is no malfunction in Step 1, 3, and 4, start the engine and maintain the idle status.
- Operate all the switches of the interior/exterior lights of the vehicle and verify that all the lights illuminate/flash.
- Operate the audio, climate control, wiper switch, and selector lever (ATX) and verify that they operate correctly.
- Shift the selector lever to the P position, race the engine at approx. 3, 000 rpm from engine idling, and verify that there is no malfunction. (ATX)
- Perform a road test and verify that low speed, acceleration, shift-up, and shift-down conditions are normal. (ATX)