PID/DATA Monitor Inspection
NOTE:
- The BARO sensor is built into the PCM. When replacing the BARO sensor, replace the PCM.
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Measure the barometric pressure using a barometer.
- Verify that the measured barometric pressure and the actually measured barometric pressure (PID: BARO) input from the BARO sensor match. (Refer to [ PID/DATA MONITOR INSPECTION
] in the troubleshooting information.) (See PCM INSPECTION [SKYACTIV-G 2.0] .)
- If the measured barometric pressure and the actually measured barometric pressure do not match, replace the PCM. (See PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.0] .)