Test 12: RCL Control Module Deactivation Output
- Using Adapter Cable (202 589 15 63 00), connect Breakout Box (124 589 00 21 00) to remote control locking control module. See Figure
. Measure voltage between terminals No. 1 and 4 at breakout box. Close and lock all doors. If less than one volt exists, go to next step. If greater than one volt exists, check the following and repair as necessary:
- Check wiring. See WIRING DIAGRAMS .
- Replace RCL control module.
- Replace combination control module.
- Measure voltage between terminals No. 1 and 4 at breakout box. Unlock vehicle using remote transmitter and keep transmitter button depressed. Vehicle should unlock, battery voltage should exist and Green indicator light should flash. If all these conditions are met, activation output is okay at this time. If any of these conditions are not met, check the following and repair as necessary:
- Check wiring. See WIRING DIAGRAMS .
- Perform TEST 3 through TEST 5.
- Replace RCL control module.
- Replace pneumatic system equipment control module.
- Replace convenience feature control module (if equipped).
- Replace anti-theft alarm control module (if equipped).
- Replace convertible top control module (if equipped).