Function of gear shift - GF27.60-P-2000GA
TRANSMISSION 722.6 in MODEL 163, 170, 202, 208, 210 with touch shift
TRANSMISSION 722.6 in MODEL 203 up to 23.4.04, 215, 220, 240 (except 215.374 /379, 220.074 /174 /179)
On transmission 722.6 the electrohydraulic control unit converts the electric signals going out from the electronic transmission control (EGS) into hydraulic signals.
Faults occurring in the ETC control unit (N15/3) are handled by the limp-home system. The limp-home system is designed so that the driver can reach a Service Operation even under extreme conditions.
Selector lever positions "P", "R", "N" and "D" are transmitted by the electronic selector lever module control unit (N15/5) on the Controller Area Network bus class C (engine compartment) (CAN-C) and in parallel to this by means of a shift rod to the range selector lever at the transmission end. By touching or holding the selector lever towards"+" or"-" the shift range is preselected and displayed in the instrument cluster (A1) until an upshift of transmission 722.6 is possible.
| Function of gear change | GF27.60-P-3010G | ||
| Emergency default mode, function | GF27.60-P-3012G | ||
| Function of manual drive mode selection | Model 163 | GF27.60-P-3011GI | |
| Model 170,202,208,210 | GF27.60-P-3011GB | ||
| Model 203 up to 31.05.03 | GF27.60-P-3011P | ||
| Model 203 as of 01.06.03 | GF27.60-P-3011PZ | ||
| Model 215, 220 up to 31.08.02 | GF27.60-P-3011GA | ||
| Models 215, 220 as of 01.09.02, 240 | GF27.60-P-3011GAZ | ||
| Oil level control, function | GF27.10-P-3024G | ||
| Torque converter lockup clutch control, function | GF27.20-P-3002G |