LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercedes Benz >> 2000 >> ML430 >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Air Bag Restraint System) >> Removal & Installation >> Control Module >> Removal & Installation (SL Class)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation (SL Class)

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 1999 Mercedes-Benz SLK230, 1999 Mercedes-Benz SL500, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, and 1999 Mercedes-Benz S320. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see SERVICE PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Remove ignition key. Remove radio. Push up and pull out heater control panel. Unplug 2 connectors. Remove screw in middle of storage tray.
  2. Bend up at top corners and lift out storage tray. Remove screws below storage tray. Lift wood trim panel at rear, pull down and out of catches. Unplug switch connectors and remove wood trim panel. Unplug connectors at control module and remove Torx mounting screws. Remove control module.
  3. To install, reverse removal procedure. Ensure SRS control module arrow points to front of vehicle. Set parameters and program new SRS control module with Hand-Held Tester (965 589 00 01 00). Activate air bag system. Perform system operation check to ensure system is functioning properly. See SYSTEM OPERATION CHECK .
scientia non olet · About LEMON Manuals