LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercedes Benz >> 2003 >> CLK430 >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P0130: Right O2 Sensor Upstream TWC (G3/4) >> Testing Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Testing Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 Mercedes-Benz ML320, 2002 Mercedes-Benz E320, 2002 Mercedes-Benz CLK320, 2001 Mercedes-Benz ML320, and 2001 Mercedes-Benz E320. However, it is still accessible from the selected car via links, so may be relevant.

O2 Signal -  Connect DVOM between ME-SFI control module connector "C" terminals No. 31 and 32 (socket box terminals No. 23 and 24). Start engine and idle. Allow engine to idle for at least 2 minutes after engine coolant temperature reaches more than 176°F (80°C). Voltage should fluctuate by more than 0.3 volts between -0.2 volts and one volt. If voltage is okay, test is complete. If voltage is not okay, possible causes are right O2 sensor (before TWC) heater failure, wiring harness failure or defective right O2 sensor (before TWC - G3/4). To check right O2 sensor (before TWC) heater failure, go to DTC P0135: O2 SENSOR HEATING OF RIGHT O2 SENSOR UPSTREAM TWC (G3/4) .

scientia non olet · About LEMON Manuals