Gear shift, function - GF27.60-P-2000NL

TRANSMISSION 722.9 in MODEL 171.4, 203, 209, 211, 219, 230 with CODE (428) Steering wheel shift buttons 

TRANSMISSION 722.9 in MODEL 171.473 

The electric controller unit (VGS) (Y3/8) converts the electrical signals from the fully integrated transmission control (VGS) into hydraulic signals. Any problems that occur are covered for by the limp-home system. This is designed to allow the driver to reach a service outlet even under extreme conditions.

The selector lever positions "P", "R", "N" and "D" are filed by the electronic selector lever module control unit (N15/5) on the Controller Area Network bus Class C (engine compartment) (CAN-C) and - in parallel - mechanically forwarded with the aid of shift rod to the selection range sensor (VGS) (Y3/8s1).

Program selection "C/S" 

The following functions can be actuated with the aid of the selector lever, left steering wheel gear shifter (S110/2) and right steering wheel gear shifter (S111/2) (vehicles up to 31.5.06 with code (428) Steering wheel shift buttons) or the steering wheel gear shifter MINUS (S110/1) and the steering wheel gear shifter PLUS (S111/1) (AMG vehicles and vehicles as of 1.6.06 with code (428) Steering wheel shift buttons):

• Preselection of shift range, up to which the transmission performs upshifts
• Direct change to drive position "D"
• Change into a gear from which the vehicle can be favorably accelerated or decelerated

Program selection "M" 

The 7 forward gears can be directly selected with the aid of the selector lever, left steering wheel gear shifter (S110/2) and right steering wheel gear shifter (S111/2) (vehicles up to 31.5.06 with code (428) Steering wheel shift buttons) or the steering wheel gear shifter MINUS (S110/1) and the steering wheel gear shifter PLUS (S111/1) (AMG vehicles and vehicles as of 1.6.06 with code (428) Steering wheel shift buttons): The shifted gear is displayed in the instrument cluster (A1).

The transmission automatically changes into the sport program "S" when the selector lever is shifted out of selector lever position "D". Gear shifts which would result in an impermissible high or low engine speeds are not executed.

In addition a mandatory downshift occurs at too low an engine speed or a mandatory upshift occurs at too high an engine speed. When the vehicle is stationary the transmission automatically shifts into 1st gear. It is possible to start off both in 1st or 2nd gear.

Drive positions "R", "P" and "N" can only be shifted to using the selector lever.

The manual shift program "M" is not stored. After restarting the engine a change is made to the sport program "S", and it is indicated in the instrument cluster (A1).