TPMS Reset Procedures: Notes

NOTE: Whenever tire pressure has been adjusted, or when wheels or tires have been replaced, the TPM system must be activated.

NOTE: Some Canadian models may be equipped with TPM system called the Tire Pressure Loss Warning System (Run Flat Indicator). It is an Indirect type system, which does not use tire pressure sensor installed on the wheels. The reset procedures are the same as the Direct type sytem, covered in this article.

If the multifunction display shows a warning message, immediately check air pressure of all tires and adjust to the specified pressure. Activate TPMS. Drive vehicle for 10 minutes to ensure warning indicators turn off.

NOTE: Tire pressure should only be adjusted on cold tires. Observe the recommended tire inflation pressure on the placard on the driver's door "B" pillar (some models may have supplemental inflation information on the fuel filler flap).