Specifications Index
164 CHASSIS SPECIFICATIONS INDEX
| System | Specification/Procedure | |
|---|---|---|
| Air Conditioning | ||
| Service | See applicable specs in DRAIN, EVACUATE AND REFILL AIR CONDITIONING | |
| Torque | TORQUE SPECIFICATIONS | |
| Axle Nut/Hub Nut (Collar Nut) | ||
| Front | TORQUE SPECIFICATIONS | |
| Rear | Stage 1: 250 Nm Stage 2: 45°∠ |
|
| Battery | TESTING & REPAIR | |
| Brakes | ||
| Bleeding Sequence | RR, LR, RF, LF | |
| Disc Brakes | See applicable components in TESTING & REPAIR | |
| Torque | TORQUE SPECIFICATIONS | |
| Charging | ||
| Generator | TESTING & REPAIR | |
| Torque | TORQUE SPECIFICATIONS | |
| Drive Belts | ||
| Adjustment | REMOVE, INSTALL POLY V-BELT | |
| Belt Routing | ROUTING DIAGRAM OF POLY V-BELT | |
| Engine Cooling | ||
| General Service Specifications | CAPACITIES & SPECIFICATIONS | |
| Radiator Cap Pressure | TEST VALUES FOR COOLING SYSTEM CAP | |
| Thermostat R & I | REMOVE/INSTALL COOLANT THERMOSTAT | |
| Water Pump R & I | REMOVE/INSTALL COOLANT PUMP | |
| Engine Mechanical | ||
| Compression | COMPRESSION PRESSURE | |
| Oil pressure | OIL PRESSURE | |
| Overhaul | TEST & ADJUSTMENT VALUES | |
| Torque | COMPLETE ENGINE -- TORQUE SPECIFICATIONS ............................................................................................ ENGINE TIMING -- TORQUE SPECIFICATIONS ............................................................................................ CRANK ASSEMBLY -- TORQUE SPECIFICATIONS |
|
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |
| Flywheel/Flex Plate Torque | TORQUE SPECIFICATIONS | |
| Fuel System | ||
| Fuel Filter Location | See illustration in REPLACE FUEL FILTER | |
| Fuel Filter R & I | REPLACE FUEL FILTER | |
| Pressure Release Procedure | A pressure gauge connection with valve is used for testing the fuel pressure and for releasing the pressure when carrying out assembly operations. See pressure gauge connection in the illustration provided in COMPONENT DESCRIPTION OF FUEL DISTRIBUTION RAIL . | |
| Pressure Specification | approx. 3.8 bar | |
| Fuel Pressure Test Procedure | A pressure gauge connection with valve is used for testing the fuel pressure and for releasing the pressure when carrying out assembly operations. See pressure gauge connection in the illustration provided in COMPONENT DESCRIPTION OF FUEL DISTRIBUTION RAIL . | |
| Ignition | ||
| Firing Order | FIRING ORDER & CYLINDER IDENTIFICATION | |
| Ignition Wires (Routing) | Coil on plug | |
| Spark Plug | ||
| Type | Bosch YR7MPP33 | |
| Gap | N/A | |
| Torque | TORQUE SPECIFICATIONS |
|
| Starting | ||
| Starter | TESTING & REPAIR | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel Alignment | ||
| Adjustment Specifications | See applicable specifications in TESTING & REPAIR | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel & Tire | ||
| Wheel Lug Nut Torque | 150 Nm | |