Remove/Install Transfer Case Control Unit - AR28.19-P-1003OLM
Model 167 with transmission 725.1
| Risk of injury . Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Put transmission into neutral position. | Otherwise damage will occur. |
|
| 2 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
| 3 | Lift vehicle with vehicle lift. | AR00.60-P-1006A | |
| 4 | Remove cover under transfer case. | AR61.30-P-1001ME | |
| 5 | Release electrical connector (1) and disconnect. | ||
| 6 | Unscrew screws (2) and remove transfer case control unit (N15/7). | Bolt, transfer case control unit to transfer case |
*BA28.19-P-1002-01B |
| 7 | Install in the reverse order. | ||
| 8 | Perform commissioning of transfer case control unit (N15/7). | When replacing the transfer case control unit (N15/7). | |
| AD00.00-P-2000-06ME | |||
| 9 | Read out and delete fault memory. | ||
| AD00.00-P-2000-06ME | |||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 10 | Conduct engine test run and check transfer case for proper operation and leak tightness while doing so. |
TRANSFER CASE ELECTRICAL SYSTEM
| Number | Designation | Model 167 | ||
|---|---|---|---|---|
| BA28.19-P-1002-01B | Bolt, transfer case control unit to transfer case | M8 | Nm | 22 |