Programming The Keys/FOBIKS - RFH Equipped

WARNING: This page is about a different car, the 2018 Fiat 500X. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Obtain the vehicle PIN before starting the routine

NOTE:

Sitting in the vehicle with the doors closed is a requirement for this routine to complete properly.

If the vehicle is equipped with a Remote Frequency Hub (RFH), perform the following procedure to program the keys/fobiks:

Connect the scan tool
Connect and confirm you have a network connection.
Navigate to the "RFH" and then "Misc Functions" menu
To add a new FOBIK, select and perform "Enable Fobiks" and follow the screen prompts to program the keys/fobs to the vehicle.

Make sure the keyfob that is being programmed is inside the car and away from nearby consumer electronics.
Remove all other keyfobs from inside the car, except the keyfob that you want to program to the vehicle.
Be prepared to press the RKE Unlock button on the keyfob when prompted towards the end of the programming routine.