LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercury >> 1985 >> Lynx Base, 4D Hatchback, 1.6 2 >> Repair and Diagnosis >> Engine Performance >> System >> Fuel Injection System - Diesel >> Testing >> Glow Plug Control Diagnosis >> Dropping Resistor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Dropping Resistor

  1. Disconnect dropping resistor (located in air intake at engine manifold) from wiring harness. Connect test lamp between dropping resistor input terminal (on wiring harness), and ground. Turn ignition to "RUN".
  2. If lamp does not light, check harness between No. 2 relay and dropping resistor. If lamp lights, go to step 3).
  3. Connect an ohmmeter to the connector terminals on the resistor. If reading is less than 1 ohm, dropping resistor is OK. If not, replace resistor.
scientia non olet · About LEMON Manuals