Test H: Sliding Door Delayed Lock Feature Inoperative
- Turn key to OFF position. Disconnect the keyless entry module 8-pin output connector located behind the left inner kick panel. Disconnect the sliding door switch connector located on the right B-pillar. Measure the resistance of the Black/White wire between the Black/White wire of the keyless entry module 8-pin output connector and the sliding door switch connector. Is the resistance less than 5 ohms? If yes, go to next step. If no, service Black/White wire. See WIRING DIAGRAMS .
- Turn key to OFF position. Remove and disconnect the sliding door switch. Measure the resistance of the sliding door switch between the Black/White wire terminal and the sliding door switch screw ground terminal with the switch in the released (door open) and depressed (door closed) positions. With the door switch in the released position, resistance should be less than 5 Ohms. With the door switch in the depressed position, resistance should be greater than 10,000 Ohms. Are the resistances okay? If yes, check the mounting screw and attachment point for corrosion. If okay, then replace the keyless entry module. See KEYLESS ENTRY MODULE under REMOVAL & INSTALLATION.