LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercury >> 1993 >> Villager LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 383 (Electronic Control Modules) >> Power Liftgate Control Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Liftgate Control Module: Installation

WARNING: This page is about a different car, the 2004 Dodge Grand Caravan, 2004 Dodge Caravan, and 2004 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the PLG control module on the D-pillar and install retaining screw. Torque the screw to 14.5 in. lbs.
  2. Connect the wire harness connections on the PLG control module. Be certain to slide connector locks to the locked position.
  3. Install the D-pillar trim panel on the vehicle. Refer to the INTERIOR article for the procedure.
  4. Connect the negative battery cable.
  5. Using an appropriate scan tool, check any erase any PLG control module diagnostic trouble codes.
  6. Verify PLG system operation. Cycle the PLG through one complete open and close cycle, this will allow the PLG control module to relearn its cycle with the new components.
scientia non olet · About LEMON Manuals