Speed Control Switch Test
NOTE:
Perform the following test only when instructed to during the Pinpoint Tests.
Turn ignition off. Access switch connector but do not unplug speed control switch connector. Measure voltage on Yellow and Black wire terminals of switch while pressing buttons as specified in the SPEED CONTROL SWITCH VOLTAGE SPECIFICATIONS table. Press only one button at a time. If voltages are as specified, return to appropriate Pinpoint Test and resume testing at last step completed. If any measurement is not as specified, replace switch assembly.
SPEED CONTROL SWITCH VOLTAGE SPECIFICATIONS
| Button | Volts | |
|---|---|---|
| Not Depressed | ||
| Yellow Wire | Less Than 1 | |
| Black Wire | Less Than 1 | |
| COAST/ACCEL | ||
| Yellow Wire | More Than 10 | |
| Black Wire | Less Than 1 | |
| CANCEL | ||
| Yellow Wire | More Than 5 | |
| Black Wire | More Than 5 | |
| RES/ACCEL | ||
| Yellow Wire | Less Than 1 | |
| Black Wire | More Than 10 | |