LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercury >> 1996 >> Villager LS >> Repair and Diagnosis >> Accessories & Equipment >> Anti-Theft Systems >> Keyless Entry System - Remote >> Testing >> Pinpoint Test D - Keypad Switch Does Not Sound
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pinpoint Test D - Keypad Switch Does Not Sound

  1. Disconnect 16-pin control module connector. Using jumper wire, connect harness connector Green/Yellow wire to ground. If keyless entry beeper does not sound, go to next step. If beeper sounds, replace lock control module.
  2. Disconnect keyless entry beeper connector. Measure voltage of Green/Red wire at connector. If more than 10 volts, go to next step. If less than 10 volts, repair Green/Red wire.
  3. Measure resistance of Green/Yellow wire between keyless entry beeper and 16-pin control module connector. If resistance is more than 5 ohms, replace Green/Yellow wire. If resistance is less than 5 ohms, replace keyless entry beeper.
scientia non olet · About LEMON Manuals