Check Wires Between ABS Control Module & Solenoids
- With ignition switch in OFF position, connect breakout box with adapter to ABS control module connector. Leave ABS control module disconnected. Disconnect hydraulic actuator assembly connector.
- Measure resistance of wires between breakout box pins and hydraulic actuator assembly connector pins specified in PINPOINT TEST D14 TEST TERMINALS table. If resistances are less than 5 ohms, go to PINPOINT TEST D15 . If resistances are more than 5 ohms, service wire(s) in question.
PINPOINT TEST D14 TEST TERMINALS
| Breakout Box Pin No. | Actuator Assembly Connector Terminal No. |
|---|---|
| 51 | 1 (Orange Wire) |
| 32 | 3 (Green/White Wire) |
| 8 | 5 (Green/Red Wire) |
| 6 | 4 (Purple Wire) |