Speed Control Switch Assembly
Turn ignition off. Access speed control switch electrical connector but do not disconnect connector. Check for voltage at Purple/Orange wire and Yellow/Blue wire terminals of speed control switch while pressing buttons as specified. See SPEED CONTROL SWITCH VOLTAGE SPECIFICATIONS table. Press only one button at a time. If voltages are as specified, go to SYSTEM TESTS and resume testing at last step completed. If voltages are not as specified, replace speed control switch.
SPEED CONTROL SWITCH VOLTAGE SPECIFICATIONS
| Button | Voltage | |
|---|---|---|
| No Button Pressed | ||
| Purple/Orange Wire | Less Than One Volt | |
| Yellow/Blue Wire | Less Than One Volt | |
| CANCEL Pressed | ||
| Purple/Orange Wire | More Than 5 Volts | |
| Yellow/Blue Wire | More Than 5 Volts | |
| COAST/SET Pressed | ||
| Purple/Orange Wire | Less Than One Volt | |
| Yellow/Blue Wire | More Than 10 Volts | |
| RES/ACCEL Pressed | ||
| Purple/Orange Wire | More Than 10 Volts | |
| Yellow/Blue Wire | Less Than One Volt | |