Cylinder Block Core Plug Replacement

Fig 1: Identifying Special Tools

Courtesy of FORD MOTOR CO.

1. Use a slide hammer or tools suitable to remove the cylinder block core plug.
   Fig 2: Removing Cylinder Block Core Plug Using Slide Hammer Or Tools

   Courtesy of FORD MOTOR CO.
2. Inspect the cylinder block plug bore for any damage that would interfere with the correct sealing of the plug. If the cylinder block plug bore is damaged, bore for the next oversize plug.
NOTE: Oversize plugs are identified by the OS stamped in the flat located on the cup side of the plug.
3. Coat the cylinder block core plug and bore lightly with Threadlock® 262 and install the cylinder block core plug.

CUP-TYPE 

CAUTION: Use care during this procedure so as not to disturb or distort the cup sealing surface.
CAUTION: When installed, the flanged edge must be below the chamfered edge of the bore to effectively seal the bore.
4. Use a tool suitable to seat the cup-type cylinder block core plug.

Fig 3: Seating Cup-Type Cylinder Block Core Plug Using Tool Suitable

Courtesy of FORD MOTOR CO.

EXPANSION-TYPE 

CAUTION: Do not contact the crown when installing an expansion-type cylinder block core plug. This could expand the plug before seating and result in leakage.
1. Use tool suitable to seat the expansion-type cylinder block core plug.

Fig 4: Seating Expansion-Type Cylinder Block Core Plug Using Tool Suitable

Courtesy of FORD MOTOR CO.