LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercury >> 2007 >> Montego Base, FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6 Speed >> In-Vehicle Servicing >> Transmission Control Module (TCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Control Module (TCM): Installation

  1. Verify that the manual lever position markings are aligned. Markings should indicate that the manual lever is in the OVERDRIVE position.
    2. Fig 1: Locating Manual Lever In Overdrive Position
    GF0017788Courtesy of FORD MOTOR CO.
  2. Install the TCM.
    • Tighten to 24 Nm (18 lb-ft).
    3. Fig 2: Locating TCM Bolts
    G03991731Courtesy of FORD MOTOR CO.
  3. Install the manual control lever.
    4. Fig 3: Locating Manual Control Lever
    G03991730Courtesy of FORD MOTOR CO.
  4. Install the manual control lever nut.
    • Tighten to 12 Nm (9 lb-ft).
    5. Fig 4: Locating Manual Control Lever Nut
    G03991729Courtesy of FORD MOTOR CO.
  5. Connect the TCM electrical connector.
    6. Fig 5: Locating TCM Electrical Connector
    G03991728Courtesy of FORD MOTOR CO.
    CAUTION: Be careful not to bend the manual control lever when installing the shift cable.
  6. Connect the shift cable end.
    7. Fig 6: Locating Shift Cable End
    G03991743Courtesy of FORD MOTOR CO.
  7. Install the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
  8. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  9. Reflash the TCM module to the latest level calibration available.
  10. Check for correct vehicle operation.
scientia non olet · About LEMON Manuals