LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercury >> 2009 >> Sable Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 377 (MULTIFUNCTION Electronic Modules System) >> Removal And Installation >> Smart Junction Box (SJB) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Smart Junction Box (SJB): Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the SJB and connect the electrical connectors.
  2. Position the SJB and install the screw
  3. Install the floor console finish panel.
  4. Install the parking brake lever boot into the floor console finish panel.
  5. Release the parking brake.
  6. Install the transmission selector lever bezel into the floor console finish panel.
  7. Install the floor console SJB cover.
  8. Connect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  9. NOTE: When successful, this step provides the calibration necessary for the SJB operation and clears DTC B2477. The clearing of the DTC indicates the calibration data has been successfully downloaded to the SJB.
  10. Download the SJB configuration information from the diagnostic tool to the SJB. For additional information, refer to MODULE CONFIGURATION .
  11. NOTE: When successful, this step clears DTCs B2868, B2869, B2870 and B2871. The clearing of these DTCs indicates the SJB has recognized the tire pressure sensors during the training procedure.
  12. Train the tire pressure sensors. For additional information, refer to WHEELS & TIRES .
  13. Clear the DTCs.
  14. NOTE: This step is required to clear DTC C2780, cause the SJB to exit the manufacturing mode, and to be sure there are no other concerns with the newly programmed SJB.
  15. Carry out the SJB on-demand self-test.
  16. Clear continuous DTCs and then check to ensure there are no additional codes present.