LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercury >> 2011 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1544 (Information System And Entertainment System) >> Removal And Installation >> Accessory Protocol Interface Module (APIM) >> Removal and Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal and Installation

WARNING: This page is about a different car, the 2011 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: It is necessary to record the current Accessory Protocol Interface Module (APIM) software and hardware level when a new APIM is being installed to make sure that the new component is the same version as the component being replaced.
  1. Retrieve and record the current APIM software and hardware level. For additional information, refer to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) SOFTWARE LEVEL CHECK .
  2. Remove the front floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
  3. Remove the 4 screws and the APIM.
    • Disconnect the electrical connector and the Universal Serial Bus (USB) cable.
  4. To install, reverse the removal procedure.
    • If a new APIM is being installed, program the APIM to the correct software level. For additional information, refer to MODULE CONFIGURATION SYSTEM article.
scientia non olet · About LEMON Manuals