Key Reader Incorrectly Shows Service Items For Replacement (M00 09 07)

Publication date: 2008-01-04
Reference number: M00 09 07

KEY READER INCORRECTLY SHOWS SERVICE ITEMS FOR REPLACEMENT

TECHNICAL SERVICE BULLETIN

Reference Number(s): SI M00 09 07, Date of Issue: January 4, 2008

MINI:	R56 (Cooper, Cooper S)
GROUP:	Maintenance and General Hints

SUBJECT

Key Reader Incorrectly Shows Service Items for Replacement

SITUATION

The Key Reader incorrectly shows items connected to the oil service as also due for service:

Intake silencer (Air cleaner)
Spark plugs
Microfilter.

CAUSE

The vehicle "Service Counter" has reset to zero. The "Service Counter" should be "1" for a vehicle prior to the first oil service.

BACKGROUND

Some maintenance items, such as microfilters or spark plugs, are permanently paired with a specific oil service interval.

The "Service Counter" is used to calculate the point at which the maintenance items that are paired with the oil service become due. If the "service counter" reads "0", this results in the situation described. All maintenance items that are paired with the oil service are then shown as "due".

The "Service Counter" value (1) and (2) can be read in the "CBS correction" test plan:

In "Diagnosis", select "Function Selection/Service functions/maintenance/CBS correction, vehicle data", and then select "Test plan".

Fig 1: Display - Service Counter Values

CORRECTION

Check the service history of the vehicle to determine the correct "Service Counter" value. (For each oil service, the "Service Counter" increases by a value of 1. For example, in a new vehicle, the "Service Counter" reads "1". After the first oil service, the "Service Counter" must therefore read "2".)

Using the Diagnosis tester, reset the oil service: Function selection/Service functions/Maintenance/Reset CBS Condition Based Service.

Repeat the oil service reset until the "Service Counter" reaches the required value.

WARRANTY INFORMATION

Covered under the terms of the MINI New Vehicle Limited Warranty.

Defect Code: 62 13 40 18 00 - Main Work*
Labor Operation: 00 99 000
Labor Allowance: Refer to KSD

*Main Work: Use this labor operation number when this is the only repair being performed, or if this is the main repair when performed along with other repairs at the same time. If this is not the main repair, refer to KSD for the associated (+) labor operation code.