LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mini >> 2008 >> Cooper Base, 2D Hatchback, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1216 (Front Axle - Repair) >> Troubleshooting >> 31 90... Front Axle Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

31 90... Front Axle Troubleshooting

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Follow troubleshooting for steering/shock absorbers.

TROUBLESHOOTING CHART

Fault Cause Remedy
Grinding noise (louder when negotiating bends) Wheel bearings faulty Replace wheel bearings
Vibration Wheel imbalance Balance wheels
Radial/lateral rim runout Check rims, replace if necessary
Radial tire runout Match or replace tires
Steering-wheel shake Wheel imbalance Balance wheels
Radial/lateral rim runout Check rims, replace if necessary
Rubber mount of control arm faulty Replace control arms
Ball joint in control arm worn Replace control arms
Rubber mount of tension strut faulty Replace rubber mounts on both tension struts
Ball joint on tension strut worn Replace both tension struts
Refer to TROUBLESHOOTING  for steering
Excessive steering wheel play/steering wheel inclination Rubber mount of control arm faulty Replace control arms
Ball joint in control arm worn Replace control arms
Rubber mount of tension strut faulty Replace rubber mounts on both tension struts
Ball joint on tension strut worn Replace both tension struts
Refer to TROUBLESHOOTING  for steering
Rattling noise Bolts for reinforcement plate loose Tighten down bolts (refer to REMOVING AND INSTALLING/REPLACING REINFORCEMENT PLATE )
Bolts for front axle carrier to engine carrier loose Replace bolts
Bolt for spring strut to swivel bearing loose Replace bolt & nut
Ball joint in control arm worn Replace control arms
Ball joint on tension strut worn Replace both tension struts
Rubber mounts for stabilizer bar bracket faulty Replace both rubber mounts of stabilizer bar bracket
Ball joints on stabilizer link(s) worn Replace both stabilizer links
Excessive tire wear Front or rear axle alignment incorrectly adjusted Check suspension components for damage; if necessary, carry out chassis/wheel alignment check