April 5, 2026: LEMON Manuals is launched! Read the announcement.

61 35 125 Removing and installing/replacing body module

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Read out PROGRAMMING/CODING .

Print out and make a note of settings for car and key memory in CKM menu

Necessary preliminary tasks:

Disconnect BATTERY NEGATIVE LEAD
Remove TRIM FOR INSTRUMENT PANEL, BOTTOM LEFT
Detach AIRBAG CONTROL UNIT WITH GATEWAY MODULE

NOTE: Open glovebox.

Unclip pin (1) from retaining strap (2).

Fig 1: Identifying Pin From Retaining Strap

G04788526

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip pin (1) from shock absorber (2).

Fig 2: Identifying Pin From Shock Absorber

G04788527

Courtesy of BMW OF NORTH AMERICA, INC.

Open rotary clips (1) and remove.

Remove cover (2) in direction of arrow.

Fig 3: Removing Cover

G05478695

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Pull fuse holder (2) back slightly.

Fig 4: Pulling Fuse Holder

G05478696

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) and disconnect.

Unlock catches (3) in direction of arrow and remove body module (2) from equipment carrier (4).

Fig 5: Removing Body Module From Equipment Carrier

G04761664

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out PROGRAMMING/CODING .

Check printed-out or noted-down settings for car and key memory in CKM menu and reset if necessary