61 13... Removing and installing/replacing fibre-optic cable connector

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Comply with notes and instructions on handling FIBRE-OPTIC CABLES .

Necessary preliminary tasks:

E60:

Remove LUGGAGE COMPARTMENT TRIM ON LEFT SIDE PANEL

E61:

Remove luggage compartment wheel arch trim on left.

Insert a small screwdriver into openings (1).

Expand catches of cover (2) and remove cover (2) in direction of arrow.

Fig 1: Removing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Fibre-optic cables with locks at top can be removed directly.
Before the fibre-optic cables with locks at the bottom are removed, the fibre-optic cable connector (4) must be removed from the holder (3).

Removing a fibre-optic cable:

Lift lock (1) carefully and feed fibre-optic cable (2) out of connector (4).

Installation:

Make sure fibre-optic cable (2) is correctly engaged in fibre-optic cable connector (4).

Fig 2: Removing Fibre-Optic Cable Connector From Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Removing connector (2) from holder (3):

Release lock in bore (1) by pressing and remove fibre-optic cable connector (2) in direction of arrow from holder (3).

Fig 3: Removing Fibre-Optic Cable Connector From Holder

Courtesy of BMW OF NORTH AMERICA, INC.