13 62 531 Replacing coolant temperature sensor
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of scalding!
Only perform these tasks on an engine that has cooled down.
Only perform these tasks on an engine that has cooled down.
Recycling
Catch and dispose of escaping oil and coolant.
Observe country-specific waste-disposal regulations.
Necessary preliminary tasks:
- Read out fault memory of DME control unit
- Switch off ignition
- REMOVE ACOUSTIC COVER
NOTE:
Coolant temperature sensor is mounted on cylinder head at front.
Unlock plug (1) and remove.
Release temperature sensor (2).
Installation:
Tightening torque 13 62 1AZ .
If necessary, top up coolant.
Check cooling system for leaks.
NOTE:
After completion of work, check engine oil level.
Check stored fault messages.
Now clear the fault memory.
Check stored fault messages.
Now clear the fault memory.