17 00... Instructions for working on cooling system
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of scalding! Work on the cooling system should only be carried out when the engine has cooled down.
IMPORTANT:
Wear protective gloves and goggles.
IMPORTANT:
Lifetime coolant filling:
Never reuse used coolant.
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be drained and refilled.
In the case of other removal work involving the draining of partial quantities of coolant, replace these quantities which have been drained with new coolant.
Never reuse used coolant.
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be drained and refilled.
In the case of other removal work involving the draining of partial quantities of coolant, replace these quantities which have been drained with new coolant.
IMPORTANT:
Open cooling system only when it has cooled down.
Opening the cooling system while hot can result in air entering the system.
This can cause overheating with permanent damage to the engine.
Opening the cooling system while hot can result in air entering the system.
This can cause overheating with permanent damage to the engine.
IMPORTANT:
When working on the oil, coolant or fuel circuit, protect the alternator against contamination.
Cover alternator with suitable materials.
Failure to comply with this procedure may result in an alternator malfunction.
Cover alternator with suitable materials.
Failure to comply with this procedure may result in an alternator malfunction.
IMPORTANT:
Do not fill coolant expansion tank over MAX level as overfilling will cause the coolant to overflow. This may give rise to traces of residual coolant on the expansion tank or in the engine compartment and wrongly suggest possible leakages.
Recycling
Catch and dispose of drained coolant.
Observe country-specific waste-disposal regulations.
NOTE:
To disconnect coolant hoses, use commercially available disconnect tools such as HAZET brand tools (see table).
HAZET TOOLS DESCRIPTION CHART
| HAZET no.: | Description |
|---|---|
| 4590-1 | Disconnect tool, length (mm): 150 |
| 4590-2 | Disconnect tool, length (mm): 180 |
| 4590-3 | Disconnect tool, length (mm): 253 |
| 4590/2 | Disconnect/plier set |
| 4590/3 | Disconnect/plier set |
NOTE:
Tightening torque, hose clamps 17 00 1AZ
.
Instructions for disassembly/assembly of coolant hose fast-release couplings
Disassembly of fast-release coupling
Withdraw lock (1/2), disconnect hose.
Installation:
Check O-rings (1).
Do not coat O-rings (1) with antiseize agent.
Assembly of fast-release coupling
Press in lock (1) before installing fast-release coupling.
Push on hose.
Fast-release coupling must clearly snap audibly into place.