Special Tools Required
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
- 00 9 340
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection)!
. See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
(Coupe) and/or 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
(Convertible).
NOTE:
C
ar C
ommunication C
omputer (CCC)
A udio S ystem K ontroller/Controller (ASK)
A udio S ystem K ontroller/Controller (ASK)
Insert special tool 00 9 340 as illustrated and unclip lower area of control panel trim (1).
Insert special tool 00 9 340 as illustrated and unclip side section of control panel (1).
Detach control panel (1) and disconnect plug connections.
Installation:
Make sure retaining clips (1) are fitted correctly.
If necessary, replace missing clips.
NOTE:
The center console switch cluster (1) and the heater/air conditioner operator unit (2) are connected via the ribbon cable (4).
Fig 4: Identifying Centre Console Switch Cluster, Heater/Air Conditioner Operator Unit & Ribbon Cable
Replacement:
IMPORTANT:
Risk of damage to operator unit (3)!
Carefully unclip operator unit trim (1) at inner retaining points (2) only.
Carefully unclip operator unit trim (2) at outer retaining points (2) only.
Remove trim (1) from operator unit (3).
Carry out programming/coding in BMW/MINI service functions in Progman.