Control unit DDE7: Notes
WARNING: This page does not describe the selected car, but rather 45 other vehicles, including the 2016 BMW M5, 2016 BMW 550i xDrive, 2016 BMW 550i, 2016 BMW 535i xDrive, and 2016 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe during renewal of a DDE control unit!
- Renewal of a control unit with which communication is still possible. Before the removal of the control unit, the individual data must be read out of the control unit with the programming system. This data is stored temporarily and must be restored in the new control unit after it has been installed.
- Renewal of a control unit with which no communication is possible any more. After renewal of the control unit, the injection quantity compensation must be performed. The codes of the injectors that are installed in the engine must be stored in the new control unit. To perform this operation, use service function Injection quantity compensation.
Introduction
The control unit connector is built modular and has, depending on the DDE version, two or five connector modules.
Ambient pressure sensor
The ambient pressure sensor is integrated in the DDE control unit and cannot be replaced separately.