Bleeding Procedures: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2006 BMW X5, 2005 BMW X5, 2004 BMW X5, 2003 BMW X5, and 2002 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Use only clean brake fluid. Ensure no dirt or other foreign matter contaminates brake fluid. DO NOT mix different brands of brake fluid, as they may not be compatible. DO NOT spill brake fluid on car, as it will damage paint. If brake fluid contacts paint, immediately flush with water.
CAUTION:
The 4.6is with M62S engine requires brake fluid DOT4 (low viscosity). All other models can be filled with the same brake fluid.
NOTE:
Check relevant operating instructions for each device. Charging pressure should not exceed 29 PSI (2 bar).
- Connect BMW Diagnosis and Information System (DIS).
- Call up service function Bleeding ABS/DSC3 Hydraulics.
- Connect bleeding unit to expansion tank and switch on.
- To flush system completely see FLUSHING BRAKE SYSTEM COMPLETELY .
- To only bleed front or rear system see BLEEDING FRONT OR REAR-AXLE BRAKE CIRCUIT .
- Switch off bleeder unit and disconnect from expansion tank.
- Check brake fluid level.
- Close expansion tank.
NOTE:
Take care of rubber gasket in lid.