1. Programming (fixed-code hand-held transmitters)

1. Switch on ignition
2. On commissioning: Press both of the outer memory buttons for approx. 20 seconds until LED 2 flashes. The three memory buttons have been deleted.
3. Hold the original hand-held transmitter at a distance of approx. 10 to 30 cm from the memory buttons. The required distance between the hand-held transmitter and memory buttons depends on the system of the original hand-held transmitter that is used.
4. Press the send button of the original hand-held transmitter and the desired memory button of the integrated universal remote control simultaneously. Initially, the LED flashes slowly. When the LED begins to flash rapidly, let go of both buttons. If the LED does not flash rapidly after approx. 15 seconds, change the distance.
5. To program other original hand-held transmitters, repeat steps  3 and  4.

The corresponding memory button is now programmed with the signal of the original hand-held transmitter.

The facility can now be operated when the ignition is switched on.

If the facility cannot be used after repeated programming, check whether the original hand-held transmitter is equipped with a random code system. Determine this either by reading the instructions for the original hand-held transmitter or by pressing the programmed memory button of the integrated universal remote control for a longer period. If the LED of the integrated universal remote control flashes for a short time and then lights up constantly for approx. 2 seconds, the original hand-held transmitter is equipped with a random code system. In the case of a random code system, program the memory buttons as described at 'Programming (random code hand-held transmitter).