62 30... Adjusting head-up display (display adjustment)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Display adjustment (correction of lopsided display) is possible from 12/2003.
The following text only describes display adjustment.
How to ADJUST THE HEIGHT OF THE HEAD-UP DISPLAY is described separately.
The following text only describes display adjustment.
How to ADJUST THE HEIGHT OF THE HEAD-UP DISPLAY is described separately.
NOTE:
Vehicles with head-up displays are fitted with special windscreens.
These windscreens are marked with the letters "HUD" on the outside at bottom right below the seal (1).
Prior to adjustment, fold seal (1) back and make sure that a correct windscreen is fitted.
These windscreens are marked with the letters "HUD" on the outside at bottom right below the seal (1).
Prior to adjustment, fold seal (1) back and make sure that a correct windscreen is fitted.
Necessary preliminary tasks:
- Check that windscreen bears the "HUD" label
- Remove ON-BOARD MONITOR
- If necessary, cover windscreen (to darken the adjustment image)
- Switch on head-up display.
- Call up test image 6 via diagnosis
IMPORTANT:
Risk of breakage!
Turn flexible shaft (1) in counterclockwise or clockwise direction only until resistance can be felt.
Turn flexible shaft (1) in counterclockwise or clockwise direction only until resistance can be felt.
Unclip flexible shaft (1) in direction of arrow from holder (2) and turn in counterclockwise or clockwise direction to adjust display.