86 21... Removing lid
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2013 BMW 135i, 2013 BMW 128i, 2012 BMW 135i, 2012 BMW 128i, and 2011 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Adjusting side lid to fit,
refer to R86 21... ADJUSTING SIDE LID TO FIT .
Adjusting rear lid to fit,
refer to R86 21... ADJUSTING REAR LID TO FIT .
refer to R86 21... ADJUSTING SIDE LID TO FIT .
Adjusting rear lid to fit,
refer to R86 21... ADJUSTING REAR LID TO FIT .
NOTE:
The text describes how to remove the lid at one rear lid mounting point as an example. Proceed in the same way for the side lids. Spare part lids are always supplied without complete locking systems.
Two persons are required for this task.
NOTE:
Open lid.
Loosen screws (1). Remove lid (2).
Installation:
Rear lid: shoulder (3) points to middle of hood.
Side lid: shoulder (3) points to outside of hood.
Tightening Torque:
refer to 86 21 7AZ, see 86 21 HOOD