67 62... Notes on initializing power windows
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Initialization
is performed on the power window switch of the relevant door.
Initialization comprises:
With normalization, the mechanical end stops of the power window regulator are recorded and stored.
The characteristic curve is learnt immediately after normalization.
When the characteristic curve is learnt, the mechanical closing forces of the power windows are recorded and stored for correct operation of the anti-trapping mechanism.
Initialization, i.e. normalization and learning of characteristic curve, is performed in a continuous operation.
Initialization comprises:
- Normalization
- Learning characteristic curve
With normalization, the mechanical end stops of the power window regulator are recorded and stored.
The characteristic curve is learnt immediately after normalization.
When the characteristic curve is learnt, the mechanical closing forces of the power windows are recorded and stored for correct operation of the anti-trapping mechanism.
Initialization, i.e. normalization and learning of characteristic curve, is performed in a continuous operation.
NOTE:
An initialization
must be performed:
- In the event of malfunctions, e.g. no one-touch function, no opening or no convenience function possible.
- After the power windows drive or door module has been replaced.
- After work is carried out on the power windows mechanism.
WARNING:
There is no anti-trap mechanism during initialization.
Necessary preliminary work:
- Vehicle stationary
- Sufficient battery voltage available/connect charger if necessary
- Terminal "15" switched on
- All doors closed
- F12 up to 02/2012 soft top open, from 03/2012 soft top closed
Operating procedure for initialization (manual):
Deleting the initialization
- Move side window into lower end position.
- Press and hold switch in "Open one-touch function" position (second switch position) for between 15 and 25 seconds.
NOTE:
Deletion of initialization was successful if toll function and anti-trap mechanism have been rendered inoperative.
Performing initialization
- Move side window to upper end position
- Pull and hold switch in "Close one-touch function" (2nd switch position) during the entire process.
NOTE:
Re-initialization was successful if toll function and anti-trap mechanism function flawlessly.
Alternatively, initialization of the power window regulation can also be carried out via the Service function in ISTA.
Selection via:
- Body
- Locking and security functions
- Power window regulator
- Initialize power window regulators
- Power window regulator
- Locking and security functions