12 90... Removing and installing/replacing electronics box

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750i, and 2015 BMW 750Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection).

NOTE: Follow instructions for removing and installing CONTROL UNITS !

Necessary preliminary work

Read fault memory.
Disconnect BATTERY EARTH LEAD .
Remove DME CONTROL UNIT .

Release screws (1).

Tightening torque 12 90 1AZ .

Unclip coolant lines at clamp (2) from electronics box.

Feed electronics box (3) out upward and remove.

Fig 1: Identifying Electronics Box, Clamp And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Identifying Engine Support Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

When installing the electronics box, insert guide (1) on engine support.