61 00... Notes on handling optical fibers
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2005 BMW 745i, 2005 BMW 745Li, 2004 BMW 745i, 2004 BMW 745Li, and 2003 BMW 745i. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
To avoid damage when handling optical fibers, comply with the following points:
- The minimum permitted bending radius is 25 mm
- Do not subject optical fibers to compressive and tensile load
- Protect optical fibers against the effects of heat 85°C (e.g. during welding work, drying work with infrared heater or hot air blower)
- Optical fibers are permitted to show only one junction point (bridge), replace optical fibers if necessary
NOTE:
The optical fibers are colored differently as follows:
- Green=MOST (Media Oriented Systems Transport) optical fibers
- Yellow=ISIS (Intelligent Safety and Integration System) optical fibers
- Orange=repair optical fibers
Follow instructions for processing cables and optical fibers. Refer to 61 13... TREATING CABLES AND OPTICAL FIBERS .