41 00... Repair solution for straight shank/hexagon rivet nut

WARNING: This page is about a different variant/trim than selected.

Protective measures!

Wear safety goggles
Wear protective gloves

IMPORTANT: To prevent the material from tapering, do not drill out the rivet head.

1. Carefully spot-drill rivet head with a larger drill bit/countersink

Fig 1: Drilling Out Rivet Head
Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Avoid paint damage
2. Knock rivet head away with a chisel

Fig 2: Removing Rivet Head With Chisel
Courtesy of BMW OF NORTH AMERICA, INC.
3. Punch through rivet shank into cavity, remove if necessary

Fig 3: Identifying Punch Through Rivet Shank Into Cavity
Courtesy of BMW OF NORTH AMERICA, INC.
4. Clean component, eliminate paint damage if necessary

Fig 4: Cleaning Bore Area
Courtesy of BMW OF NORTH AMERICA, INC.

If the rivet shank can be removed:

IMPORTANT: To avoid corrosion, stop chips/debris by means of cavity preservation.

Follow NOTES ON CORROSION PROTECTION .
5. Preserving cavity

Fig 5: Preserving Cavity
Courtesy of BMW OF NORTH AMERICA, INC.

If the rivet shank cannot be removed:

WARNING: Danger of injury!
Observe NOTES ON CAVITY FOAM .

IMPORTANT: To avoid corrosion and rattling noises, stop chips/debris and rivet nut shank with cavity foam.
Remove foam remnants with isohexane (benzine).

Fig 6: Preserving Cavity
Courtesy of BMW OF NORTH AMERICA, INC.
5. Stop rivet shank by means of specific foaming
6. Set rivet nut with hand rivet gun

NOTE: Fit rivet nut as quickly as possibly, ideally before the cavity foam hardens.

Hexagon/straight shank rivet nut (up to thread M8) with hand rivet gun ZS308

IMPORTANT: Follow manufacturer's operating instructions.
Make sure rivet nut correctly contacts component.

NOTE: According to the manufacturer, the pictured tool is suitable up to an M8 thread (see BMW Aftersales Assistance Portal (ASAP) - Service/Technology - Workshop Equipment.

Fig 7: Setting Rivet Nut Using Hand Rivet Gun

Courtesy of BMW OF NORTH AMERICA, INC.

Hexagon/straight shank rivet nut (up to thread M12) with hand rivet gun MB512

IMPORTANT: Follow manufacturer's operating instructions.
Make sure rivet nut correctly contacts component.

Fig 8: Installing Hexagon/Straight Shank Rivet Nut With Hand Rivet Gun MB512

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: According to the manufacturer, the pictured tool is suitable up to an M12 thread (see BMW Aftersales Assistance Portal (ASAP) - Service/Technology - Workshop Equipment.