61 00... Notes on handling optical fibers
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2007 BMW 530xi. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
To avoid damage when handling optical fibers, comply with the following points:
- The minimum permitted bending radius is 25 mm
- Do not subject optical fibers to compressive and tensile load
- Protect optical fibers against the effects of heat greater than 85°C (e.g. during welding work, drying work with infrared heater or hot air blower)
- Optical fibers are permitted to show only one junction point (bridge), replace optical fibers if necessary
NOTE:
The optical fibers are colored differently as follows:
- Green=MOST (M edia O riented S ystems T ransport) optical fibers
- Yellow=ISIS (I ntelligent S afety and I ntegration S ystem) optical fibers
- Orange=repair optical fibers
Follow instructions for TREATING CABLES AND FIBRE-OPTIC CABLES .