86 10 ... Disassembly Of Loading Ramp Frame/Disassembly Of Rail, Left/Right
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Two persons are required to disassemble the loading ramp frame.
Disassembly of license plate mounting plate, refer to 86 10 ... DISASSEMBLY OF LICENSE PLATE mounting plate.
Disassembly of pull rod, refer to 86 10 ... DISASSEMBLY OF OVERRUNNING EQUIPMENT .
Disassembly of license plate mounting plate, refer to 86 10 ... DISASSEMBLY OF LICENSE PLATE mounting plate.
Disassembly of pull rod, refer to 86 10 ... DISASSEMBLY OF OVERRUNNING EQUIPMENT .
Release screws (1) of loading ramp frame (2) on cross-strut (3).
Installation:
Tightening Torque. Refer to TRAILERS - TIGHTENING TORQUES - ALPINA .
Release screws (1, 2) on left and right sides of loading ramp frame (3).
Installation:
Use new self-locking nuts.
Tightening Torque. Refer to TRAILERS - TIGHTENING TORQUES - ALPINA .
Release screws (1, 2, 3).
Installation:
Use new self-locking nuts.
Tightening Torque. Refer to TRAILERS - TIGHTENING TORQUES - ALPINA .