12 90... Removing and installing/replacing electronics box

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection).

NOTE: Follow instructions for removing and installing CONTROL UNITS!

Necessary preliminary work

Read fault memory.
Disconnect BATTERY EARTH LEAD.
Remove DME CONTROL UNIT .

Release screws (1).

Tightening torque 12 90 1AZ.

Unclip coolant lines at clamp (2) from electronics box.

Feed electronics box (3) out upward and remove.

Fig 1: Identifying Electronics Box, Clamp And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

When installing the electronics box, insert guide (1) on engine support.

Fig 2: Identifying Engine Support Guide

Courtesy of BMW OF NORTH AMERICA, INC.