86 21... Installing sponge rubber seal

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2013 BMW 135i, 2013 BMW 128i, 2012 BMW 135i, 2012 BMW 128i, and 2011 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removing old sponge rubber seal: Pull off old sponge rubber seal. Remove remaining traces of adhesive with universal cleaner.

Sponge rubber seal runs along area marked gray (1).

Fig 1: Identifying Sponge Rubber Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Lay sponge rubber seal (1) in middle of hood contact surface (2).

Installation:

Degrease contact surface (2) with benzine and rub down with a dry cloth. Stick on sponge rubber seal (1) according to manufacturer's instructions. Position end face of seal (1) in a straight area.

Fig 2: Identifying Sponge Rubber Seal In Middle Of Hood Contact Surface

Courtesy of BMW OF NORTH AMERICA, INC.