86 10... Removing loading ramp lock: Installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Tightening Torque,

refer to 86 10 28AZ, see 86 10 PLATFORM .

Fig 1: Identifying Loading Ramp Lock And Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Pass lever (1) of rotary striker lock (2) out of square hole (3) by twisting from side to side.

Fig 2: Pass Lever (1) Of Rotary Striker Lock (2)

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew bolts (1).

Opening for securing clip (2) points to front or rear.

Square-head nut (3) rests with its square surface parallel to bearing pedestal (4).

Tightening Torque,

refer to 86 10 29AZ, see 86 10 PLATFORM .

Fig 1: Square-Head Nut (3) Rests With Its Square Surface Parallel To Bearing Pedestal (4)

Courtesy of BMW OF NORTH AMERICA, INC.

Raise edge (1) of securing clip and slide in direction of arrow towards rear.

Detach bearing pedestal (2).

Fig 2: Detaching Bearing Pedestal

Courtesy of BMW OF NORTH AMERICA, INC.

Install bearing pedestal (1) on stub (3) of locking bracket (3).

Off-center bore (4) in bearing pedestal (1) points with short distance (A) to locking bracket (3).

Fig 1: Identifying Off-Center Bore In Bearing Pedestal Points With Short Distance

Courtesy of BMW OF NORTH AMERICA, INC.