86 10... Removing rear supports and bracket: Installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Tightening Torque,

refer to 86 10 26AZ, see 86 10 PLATFORM .

Fig 1: Identifying Rear Support From Bracket And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cable holders (1) from bracket (2). Release screws (3) on left and right sides of bracket (2). Drill out rivets (4) from underside of platform. Drill out rivets (5) from upper side of platform.

Tightening Torque,

refer to 86 10 27AZ, see 86 10 PLATFORM .

Fig 1: Remove Cable Holders From Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Feed cable for rear light (1) through opening (2). Fit cable holders (4) in holes (3).

Fig 1: Fitting Cable Holders In Holes

Courtesy of BMW OF NORTH AMERICA, INC.