61 00... Notes On Handling Optical Fibers
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760Li, 2005 BMW 760Li, and 2004 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
To avoid damage when handling optical fibers, comply with the following points:
- The minimum permitted bending radius is 25 mm.
- Do not subject optical fibers to compressive and tensile load.
- Protect optical fibers against the effects of heat "GREATER THAN EQUALS TO" 85° C (e.g. during welding work, drying work with infrared heater or hot air blower).
- Optical fibers are permitted to show only one junction point (bridge), replace optical fibers if necessary.
NOTE:
The optical fibers are colored differently as follows:
- Green =MOST (M edia O riented S ystems T ransport) optical fibers.
- Yellow =ISIS (I ntelligent S afety and I ntegration S ystem) optical fibers.
- Orange = repair optical fibers.
Follow instructions for Treating cables and fibre-optic cables