67 62 ... Notes On Initializing Power Window
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, and 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Initialization
is performed on the power window switch of the relevant door.
Initialization comprises:
- Normalization.
- Learning characteristic curve.
With normalization, the mechanical end stops of the power window are recorded and stored.
The characteristic curve is learned immediately after normalization.
When the characteristic curve is learned, the mechanical closing forces of the power window are recorded and stored for correct operation of the anti-trapping mechanism.
Initialization, i.e. normalization and learning of characteristic curve, is performed in a continuous operation.
NOTE:
An initialization
must be performed:
- In the event of malfunctions, e.g. no one-touch function, no opening or no comfort function possible.
- After the power window drive or door module has been replaced.
- After work is carried out on the power window mechanism.
WARNING:
There is no anti-trapping protection during initialization.
Operating sequence for initialization:
- Move side window into lower end position.
- Press switch into "Open one-touch operation" (second switch position) for approx. 15 to 25 sec. and hold down.
- Release switch, then immediately press into "Close onetouch operation" (second switch stage) and hold down.
- The side window now moves to the lower end position and then back to the upper end position.
Initialization is completed once the side window has returned to the upper end position.
NOTE:
Carry out function check (one-touch function, anti-trapping protection and, if necessary, comfort function).