Rectangular Waterproof Connector

Foreword
A loose connector should be rectified by removing female terminal from connector housing and raising its lance to establish a more secure engagement.

Rectangular Waterproof Connector:

1. Disengage front holder by using a screwdriver and remove it.

Rectangular Waterproof Connector:

2. Insert tip of screwdriver [0.8 mm (0.03 in) width] into connector in a manner as shown in the figure, push it lightly to raise housing lancer and pull out harness.

NOTE: If right size screwdriver is not available, convert a conventional driver to suit the size.

Rectangular Waterproof Connector:

3. Press contact point of male terminal down by holding a screw driver [1.4 mm (0.06 in) width] in a manner as shown in the figure.