Cruise Control Switch Test
Disconnect cruise control switch harness connector. Check continuity or resistance between switch terminals. See CRUISE CONTROL SWITCH TEST table. Replace as necessary.
CRUISE CONTROL SWITCH TEST
| Switch Position | Condition | |
|---|---|---|
| OFF | No Continuity | |
| CANCEL Switch On | ||
| Between Terminals No. 1 & 3 | About 3900 Ohms | |
| Between Terminals No. 2 & 3 | About Zero Ohms | |
| RESUME Switch On | ||
| Between Terminals No. 1 & 3 | About 4800 Ohms | |
| Between Terminals No. 2 & 3 | About 910 Ohms | |
| SET Switch On | ||
| Between Terminals No. 1 & 3 | About 4100 Ohms | |
| Between Terminals No. 2 & 3 | About 220 Ohm | |
| ON | ||
| Between Terminals No. 1 & 2 | About 3900 Ohms | |